Soldered.com ↗ GitHub ↗
Full product documentation, content & links

Soldered Electrochemical Gas Sensor Breakout (Qwiic)

Qwiic Ecosystem › Qwiic Sensors
Sensors & Modules › Environmental (Temp, Humidity, Gas)
New Arrivals
Interface ['i2c', 'analog', 'digital_gpio'] Qwiic Yes

Analog front end for SGX-4 electrochemical gas cells. It biases the cell, reads it with a 16-bit ADC and reports over Qwiic.

This board reads SGX-4 series electrochemical gas cells. The LMP91000 analog front end biases the cell and turns its current into a voltage, a 16-bit ADS1115 ADC converts that voltage, and an ATtiny404 talks to both chips for you, so your microcontroller sees a single I2C device.


The LMP91000's bias, gain and load resistor are set over I2C, so the same board works with different cells. The libraries carry ready presets for CO, NO2, SO2, O3, NO, H2S, NH3 and Cl2 cells, and you can set every register yourself for other cells. An MCP1525 gives the front end a 2.5 V reference. The ADS1115's other three inputs, AIN1 to AIN3, are on a header for your own analog signals.


Connect the board with either of the two Qwiic connectors or the 2.54 mm headers. It runs from 3.3 V; there is no regulator, so the header and the Qwiic connectors share one 3.3 V supply. The default address is 0x30; the three DIP switches move it from 0x30 to 0x37, so up to eight boards share one bus. The front end's analog output VOUT and the ADC's ALERT pin are on the header too. There are libraries for Arduino and MicroPython, plus an ESP-IDF component and an ESPHome component.

  • Analog front end: Texas Instruments LMP91000
  • ADC: Texas Instruments ADS1115, 16-bit, 4 inputs
  • Bridge MCU: Microchip ATtiny404 (factory firmware)
  • Voltage reference: MCP1525, 2.5 V
  • Gas cell: SGX-4 series electrochemical cell, 3-electrode
  • Interface: I2C, address 0x30 (0x30 to 0x37 by switch)
  • Supply: 3.3 V, no regulator; the Qwiic connectors share this supply
  • Header pins: VOUT (analog out), ALERT, AIN1 to AIN3 (analog in)
  • Connectors: 2x Qwiic, 2.54 mm headers
  • Dimensions: 38 x 38 mm
  • Mounting holes: 4x 3.2 mm

Interface

Interface I2C, Analog, Digital Gpio
Qwiic Compatible Yes
I2C Address Default 0x30
I2C Address Changeable Yes
Breadboard Compatible No

Measurement

Measurement Types Gas

Power

Supply Voltage Min V 3.3
Supply Voltage Max V 3.3
Logic Level 3V3 Only

Other

Ic Part Number LMP91000
Mcu Part Number ATtiny404
Start Here
1
Connect

Plug into any Soldered Dasduino or microcontroller with an easyC cable — no soldering required.

2
Install the library

Add the Soldered library for your language (below).

3
Run an example

Open the get-started example and read your first value.

ArduinoC++
MicroPythonPython
What's in the Box
1×
Soldered Electrochemical Gas Sensor Breakout (Qwiic) (main product) 333417
1×
Header pins (unsoldered)
Header pins included for all breadboard-compatible pins
Pinout
Last updated: